The Skipper wall & magnetic support brackets are hugely practical accessories for the Skipper unit, and are perfect for use on Vans, FLT's, Racking, etc.

 The wall version can be screwed into place for permanent/semi-permanent use, and the non-marking magnetic version, quickly set-up onvehicles, etc. 

The suction pad holder/receiver can also be used as a receiver clip for the standard Skipper unit, and as a support for the Skipper recycle bins and safety dispensers. Simply position the suction pad onto a glass or high gloss surface and pull down the arm for an extremely strong connection.

The Skipper XS range of products were developed to adapt Skipper’s great versatility to indoor environments such as in warehousing, manufacturing and facilities management – where room for cones and posts is not available.

This A4 sign holder is designed for use with both Skipper and Skipper XS units.

Simply insert your A4 message into the polycarbonate sleeve, and slide into the robust u-shaped frame. 

The safety light has a light sensor for automatic activation/deactivation, or can be set to full manual control.

Twist off the Skipper or Skipper XS unit’s top cap and twist the options  into position.

A dummy unit has the same body as a standard Skipper unit, but contains no tape. The Dummy unit is used to act as a receiver for the Skipper unit’s tape end clip.

The Stanchion for Skipper safety barriers. The Skipper post and base system is the perfect complement to the Skipper unit.

Combine with the Skipper unit to create a stanchion post with retractable belt.

9m internal barrier kit (cord strap clips). Creates a 9m barrier.

What’s in the kit:

1X Skipper XS unit

2X cord strap holder/receiver

Create safe areas with this cone top retractable tape barrier kit.

Each Skipper unit contains 9m (30′) of high visibility fabric tape, this kit gives you up to 36m of easy-to-deploy barrier. 

The clamp holder/receiver is used to attach the Skipper XS unit and/or tape end to angular surfaces such as door frames, work surfaces and racking.

The clamp holder/receiver is used to attach the Skipper XS unit and/or tape end to angular surfaces such as door frames, work surfaces and racking.